Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Front Suspension Crossmember Installation Hole | φ25 (0.98) |
| B, b | Frame Front Lower Crossmember Standard Hole | φ13 (0.51) |
| C, c | Frame Rear Lower Crossmember Standard Hole | φ13 (0.51) |
| D, d | Front Suspension Lower Arm Installation Hole | φ15 (0.59) |
| E | Front Suspension Crossmember Installation Hole | φ28.7 (1.13) |
| e | Front Suspension Crossmember Installation Hole | φ29 (1.14) |
| *a | mm
(in.) |
- | - |
| *a | Imaginary Datum Line | *b | Height from Imaginary Datum Line |
| *c | mm
(in.) |
- | - |