for Gasoline Model
Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Rear Suspension Crossmember Installation Hole | φ64 (2.52) |
| B, b | Rear Suspension Lower Member Standard Hole | φ15 (0.59) |
| C, c | Rear Suspension No. 1 Arm Installation Hole | φ14.2 (0.56) |
| D, d | Upper Control Arm Installation Hole | φ14.2 (0.56) |
| E, e | Rear Suspension No. 2 Arm Installation Hole | 22.2X14.2
(0.87X0.56) |
| F, f | Rear Suspension Control Inner Arm Bracket Standard Hole | φ15 (0.59) |
| G, g | Rear Suspension Crossmember Installation Hole | φ75 (2.95) |
| *a | mm
(in.) |
- | - |
| *a | Imaginary Datum Line | *b | Height from Imaginary Datum Line |
| *c | mm
(in.) |
- | - |
for HV Model
Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Rear Suspension Crossmember Installation Hole | φ64 (2.52) |
| B, b | Rear Suspension Lower Member Standard Hole | φ15 (0.59) |
| C, c | Rear Suspension No. 1 Arm Installation Hole | φ14.2 (0.56) |
| D, d | Upper Control Arm Installation Hole | φ14.2 (0.56) |
| E, e | Rear Suspension No. 2 Arm Installation Hole | 22.2X14.2
(0.87X0.56) |
| F, f | Rear Suspension Control Inner Arm Bracket Standard Hole | φ15 (0.59) |
| G, g | Rear Suspension Crossmember Installation Hole | φ75 (2.95) |
| *a | mm
(in.) |
- | - |
| *a | Imaginary Datum Line | *b | Height from Imaginary Datum Line |
| *c | mm
(in.) |
- | - |