With the radiator side support assembly removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut with Disc Sander etc. |
|
Cut and Join Location |
| *a | 175 mm (6.89 in.) | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Plug Weld |
|
Cut and Join Location |
|
Butt Weld |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
If the entire supply part is not needed, remove the part of the supply part that is needed.
| *1 | FRONT APRON TO COWL SIDE MEMBER OUTER FRONT | - | - |
| *a | 175 mm (6.89 in.) | - | - |
Weld the front fender apron extension front to the vehicle side.
| *1 | FRONT FENDER APRON EXTENSION FRONT | - | - |
Weld the front apron to cowl side member outer front and front fender apron gusset lower to the vehicle side.
| *1 | FRONT APRON TO COWL SIDE MEMBER OUTER FRONT | *2 | FRONT FENDER APRON GUSSET LOWER |
Weld the front fender apron gusset upper to the vehicle side.
| *1 | FRONT FENDER APRON GUSSET UPPER | - | - |
After welding, apply body sealer to the corresponding parts. (See the painting /coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.