CONSTRUCTION
The crankshaft design has been optimized to reduce weight.
The crankshaft has 5 main bearing journals and 8 balance weights.
A balance shaft drive gear is provided on the crankshaft.
| *a | No. 1 Main Bearing Journal | *b | No. 2 Main Bearing Journal |
| *c | No. 3 Main Bearing Journal | *d | No. 4 Main Bearing Journal |
| *e | No. 5 Main Bearing Journal | *f | Balance Shaft Drive Gear |
| *g | Balance Weight | - | - |
The oil groove on the crankshaft bearing is made eccentric to reduce the amount of oil leakage from the bearing. This enables the capacity of the oil pump assembly to be reduced in order to reduce parasitic losses.
Aluminum alloy is used for the crankshaft bearings. The inner surface of the No. 1, No. 3 and No. 5 crankshaft bearings has a solid lubrication overlay applied.
Lead-free materials have been used for the crankshaft and crankshaft bearing in consideration of environmental issues.
| *A | Type A | *B | Type B |
| *1 | Upper Main Bearing (Crankshaft Bearing) | *2 | Lower Main Bearing (Crankshaft Bearing) |
| *a | Oil Groove | *b | Oil Groove Depth |
| *c | Center | *d | Edge |
|
Engine Front |
|
Overlay |