SYSTEM CONTROL
When the driver switches from the brake pedal to the accelerator pedal when starting off on a hill, hill-start assist control maintains the brake fluid pressure of all 4 wheels to prevent the vehicle from rolling backward.
When starting off on a hill, hill-start assist control allows the driver to slowly switch from the brake pedal to the accelerator pedal in a relaxed manner without the vehicle rolling backwards. Furthermore, occasions in which the parking brake is required to prevent the vehicle from rolling backward has been minimized.
When starting off on a hill with a slippery road surface, the driver does not need to swiftly depress the accelerator which can lead to unnecessary wheel spin.
| *a | With Hill-start Assist Control | *b | Without Hill-start Assist Control |
| *c | Brakes applied to prevent the vehicle from rolling backwards | - | - |
Hill-start Assist Control Initiation Conditions
The No. 2 skid control ECU (brake actuator assembly) judges if the vehicle is on an uphill slope based on signals from the acceleration sensor, and activates hill-start assist control when all of the following conditions are met.
·
The shift lever is in any position other than P or N. (Climbing with the front or rear of the vehicle toward the hilltop) ·
The vehicle is stationary. ·
The accelerator pedal is not depressed. ·
The parking brake is released. |
Hill-start Assist Control Cancellation Conditions
If any of the following conditions are met, hill-start assist control is canceled.
·
The shift lever is moved to P or N. ·
The accelerator pedal is depressed. ·
The parking brake is applied. ·
Approximately 2 seconds have elapsed since hill-start assist control began. |