Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM (for HV Model)
NM37A0E _54 Brake _086687 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0418462 BRAKE CONTROL SYSTEM(for HV Model) CO CONTROL F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM(for HV Model)  CONTROL  SECONDARY COLLISION BRAKE  


SYSTEM CONTROL


a.

The secondary collision brake system lessens damage from a secondary collision by controlling the automatic brakes and stop light illumination after a collision occurs.


b.

When the airbag sensor assembly detects a collision and operates the airbags, it sends a collision detection signal to the No. 2 skid control ECU (brake actuator assembly). When the No. 2 skid control ECU (brake actuator assembly) receives a collision detection signal, it determines that operation can start, operates the brake actuator and performs braking. Simultaneously, the No. 2 skid control ECU (brake actuator assembly) sends a stop light illumination request to the stop light switch assembly, illuminating the stop lights.

X145250E01
0.646,1.458 2.302,1.99 1.656,0.531 10 false Airbag Sensor Assembly 0.573,2.146 2.302,2.688 1.729,0.542 10 false Hybrid Vehicle Control ECU 0.677,3.083 2.542,3.604 1.865,0.521 10 false Network Gateway ECU 0.542,3.938 2.406,4.458 1.865,0.521 10 false Combination Meter Assembly 3.167,0.177 4.146,0.688 0.979,0.51 10 false Brake Actuator Assembly 5.052,4.313 6.844,4.542 1.792,0.229 10 false : CAN Communication Line 3.167,1.708 4.01,2.188 0.844,0.479 10 false No. 2 Skid Control ECU 4.531,1.479 5.385,1.969 0.854,0.49 10 false Wheel Speed Signal 4.417,2.375 5.438,3.167 1.021,0.792 10 false Stop Light Illumination Request Signal 5.813,1.271 6.979,1.552 1.167,0.281 10 false Speed Sensors (4) 5.771,2.042 6.875,2.552 1.104,0.51 10 false Stop Light Switch Assembly 5.979,3.302 6.802,3.615 0.823,0.313 10 false Stop Light 5.531,2.729 6.271,3.26 0.74,0.531 10 false Stop Lights Illumination


c.

Secondary Collision Brake Operation Start Condition

i.

When a collision detection signal is received from the airbag sensor assembly while the vehicle speed is approximately 10 km/h (6 mph) or more, the secondary collision brake starts operating.

HINT:

When a system malfunction is displayed on the multi-information display or the system is in test mode or maintenance mode, the secondary collision brake is prohibited from operating.




d.

Secondary Collision Brake Operation Cancellation Condition

i.

If one of the following conditions is detected, operation of the secondary collision brake is canceled.

Secondary Collision Brake Operation Cancellation Conditions
·

The vehicle speed is below approximately 10 km/h (6 mph).

·

Operation continues for a certain period of time.

·

After operating, the accelerator pedal is depressed a certain amount or more.