Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
NM37A0E _59 Vehicle Exterior _086696 WIPER / WASHER _0419450 WIPER AND WASHER SYSTEM DE DETAILS F

WIPER / WASHER  WIPER AND WASHER SYSTEM  DETAILS  WASHER NOZZLE  


CONSTRUCTION


a.

Front Washer Nozzle

i.

Diffuser type washer nozzle sub-assemblies are located under the engine hood to ensure good appearance.


ii.

With the adoption of the diffuser type washer nozzle sub-assemblies, only a small amount of washer fluid is needed to spray over a large area, realizing excellent wiping performance.

Y256340C01
0.354,0.896 0.604,0.896 0.604,0.896 1.031,1.729 true 4.188,2.521 4.188,2.021 true 0.177,0.781 0.396,1 0.219,0.219 10 false *1 6.521,0.885 6.729,1.083 0.208,0.198 10 false *a 6.573,1.771 6.76,1.958 0.188,0.188 10 false *b 4.135,2.552 4.354,2.771 0.219,0.219 10 false *1
*1 Washer Nozzle Sub-assembly - -
*a Fluid Volume *b Main Flow Center


HINT:

Diffuser type washer nozzle sub-assemblies cannot be adjusted because of their structure. Do not attempt to adjust the nozzles as it could damage them. If adjustment is necessary, adjust the spray pattern by replacing the nozzles with those selected from the 3 part numbers available. For details, refer to the Repair Manual.




b.

Rear Washer Nozzle

i.

Spray type rear washer nozzle is located on the back door panel.

Y256341C01
0.469,0.656 0.927,0.656 true 1.635,1.26 2.563,1.01 2.563,1.01 2.729,1.01 true 0.24,0.552 0.458,0.75 0.219,0.198 10 false *1 2.781,0.917 3.01,1.125 0.229,0.208 10 false *2 4.031,0.594 4.25,0.792 0.219,0.198 10 false *a 2.292,0.115 2.448,0.313 0.156,0.198 10 false A
*1 Back Door Panel *2 Rear Washer Nozzle
*a View from A - -




c.

Washer Nozzle Heater (Models with Washer Nozzle Heater)

i.

When the outside temperature meets or falls below a fixed level, the PTC heater is activated based on signals from the WSH NZL HTR relay to prevent water inside the nozzle from freezing and blocking the washer fluid.

Y259150C01
5.25,0.833 5.667,0.833 5.667,0.833 6.417,2.25 true 1.552,2.76 1.76,2.948 0.208,0.188 10 false *1 5.052,0.74 5.229,0.927 0.177,0.188 10 false *2 5.594,2.667 5.802,2.854 0.208,0.188 10 false *a 0.104,1.531 0.26,1.729 0.156,0.198 10 false A 3.594,1.552 3.75,1.75 0.156,0.198 10 false A
*1 Washer Nozzle Sub-assembly *2 PTC Heater
*a A-A Cross Section - -