CONSTRUCTION
By supplying ATF from the oil pump (mechanical type) on the main shaft, through the oil cooler assembly (air-cooled type), and then through the upper return line to the upper transmission, the generator (MG1) and motor (MG2) can be suitably cooled with a small quantity of oil and churn losses have been reduced. Furthermore, by use of the motor cooling cooler (water-cooled type) and by driving the oil pump with motor assembly, the motor (MG2) can be suitably cooled. As the cooling capacity has been enhanced, the generator (MG1) and motor (MG2) have been downsized while power output has been increased.
The hybrid vehicle transaxle assembly is lubricated by a trochoid type oil pump placed on the main shaft and the oil pump with motor assembly.
The oil pump with motor assembly is controlled by the hybrid vehicle control ECU. The hybrid vehicle control ECU drives the oil pump with motor assembly based on the vehicle speed signal and the temperature sensor signals of the generator (MG1) and motor (MG2).
| *1 | Return Cooler Pipe | *2 | Hybrid Vehicle Transaxle Assembly |
| *3 | Oil Pump with Motor Assembly | *4 | Oil Cooler Assembly (Air-cooled Type) |
| *5 | Oil Pump | *6 | Motor Cooling Cooler (Water-cooled Type) |
|
ATF Flow | - | - |
The oil pump with motor assembly consists of a trochoid type oil pump, motor and motor driver.
The trochoid type oil pump is driven by the motor.
The motor is operated using duty control performed by the motor driver based on signals from the hybrid vehicle control ECU.
| *1 | Motor Driver | *2 | Motor |
| *3 | Shaft | *4 | Drive Rotor |
| *5 | Driven Rotor | *6 | Hybrid Vehicle Control ECU |