CONSTRUCTION
2 front support points and 1 rear support point using rubber mounts are used to reducing vibration and noise.
The front mount is installed on the rear suspension member sub-assembly via the front differential support assembly.
An aluminum front differential support assembly is used to achieve weight reduction.
| *1 | Front Mount RH | *2 | Front Differential Support Assembly |
| *3 | Front Mount LH | *4 | Differential Mount Cushion |
| *5 | Rear Suspension Member Sub-assembly | *6 | Upper Differential Mount Stopper |
| *7 | Lower Differential Mount Stopper | - | - |
| *a | A-A Cross Section | *b | B-B Cross Section |
|
Front | - | - |