CONSTRUCTION
A disconnect mechanism is used in the transfer. When current flows to the dog clutch solenoid, the mechanism switches between connected and disconnected.
A large diameter unit ball bearing is used in the support portion of the ring gear. This allows the disconnect mechanism to be placed inside the ring gear, achieving size and weight reductions.
An edge surface contact type dust lip is used for the oil seal on the transfer output shaft axis.
| *1 | Transfer Ring Gear | *2 | Oil Seal |
| *3 | Transfer Output Shaft | *4 | Front Dog Clutch Solenoid |
| *5 | Ball Bearing | - | - |
OPERATION
Transfer Power Flow
The illustration below shows the flow of power from the transaxle:
| *1 | Differential Case | *2 | Transfer Input Shaft |
| *3 | Clutch Sleeve | *4 | Transfer Ring Gear |
| *5 | Transfer Driven Pinion Gear | *6 | Transfer Output Shaft |
| *7 | Propeller Shaft | - | - |
|
Power Flow | - | - |