CONSTRUCTION
FD15ED Type Rear Differential
A disconnect mechanism is used in the differential. When current flows to the dog clutch solenoid, the mechanism switches between connected and disconnected.
The electro magnetic control coupling sub-assembly is placed in front of the differential.
A large diameter unit ball bearing is used in the support portion of the ring gear. This allows the disconnect mechanism to be placed inside the ring gear, achieving size and weight reductions.
The gear ratio of the rear differential is set lower than that of the transfer. As a result, even though the rotation difference is absorbed by the coupling, the speed of the input side (before coupling) is set higher than the speed of the output side (after coupling), helping reduce driveline backlash and improve torque response.
| *1 | Electro Magnetic Control Coupling Sub-assembly | *2 | Ball Bearing |
| *3 | Differential Ring Gear | *4 | Pinion Gear |
| *5 | Side Gear | *6 | Rear Differential Case |
| *a | Electromagnetic Control Coupling Portion | *b | Disconnect Mechanism Portion |
OPERATION
Rear Differential Power Flow
The illustration below shows the flow of power transmitted from the propeller shaft assembly:
| *1 | Propeller Shaft | *2 | Front Housing |
| *3 | Main Clutch | *4 | Shaft |
| *5 | Differential Drive Pinion | *6 | Differential Ring Gear |
| *7 | Clutch Sleeve | *8 | Differential Case |
| *9 | Pinion Shaft | *10 | Pinion Gear |
| *11 | Side Gear | *12 | Intermediate Shaft |
| *13 | Rear Drive Shaft | - | - |
|
Power Flow | - | - |