FUNCTION OF MAIN COMPONENTS
| Component | Function |
|---|---|
|
*1: w/ DAB Function *2: w/ Navigation Antenna Assembly *3: for Gasoline Model *4: for HV Model |
|
| Radio and Display Receiver Assembly | ·
Outputs the audio signal of the selected audio source to the speakers. ·
Sends each sound source and hands-free system status to the combination meter. |
| Speakers | Output the audio sounds. |
| Roof Antenna Assembly
·
AM ·
FM MAIN |
·
Receives radio broadcasting signals. (AM/FM) ·
Amplifies radio broadcasting signals from the radio antenna and sends them to the radio and display receiver assembly. (antenna amplifier) |
| Window Glass Antenna Wire
·
FM SUB ·
DAB*1 |
·
Receives FM radio broadcasts via the rear window glass antenna printed antenna array. ·
Receives digital audio broadcasts via the DAB antenna printed antenna array.*1 |
| No. 1 Amplifier Antenna Assembly | Amplifies radio broadcasting signals from the radio antenna and sends them to the radio and display receiver assembly. |
| Digital Audio Broadcasting Antenna Assembly*1 | Amplifies DAB signals from the DAB antenna and sends them to the radio and display receiver assembly. |
| Navigation Antenna Assembly*2
·
GPS |
Receives signals from GPS satellites and transmits these signals to the radio and display receiver assembly. |
| Steering Pad Switch Assembly | Sends operation signals such as volume adjustment, mode selection and song selections to the radio and display receiver assembly. |
| Telephone Microphone Assembly | ·
Detects voice during hands-free conversations and voice commands. ·
Is installed in the map light assembly and converts sound waves to an electrical signal and sends it to the radio and display receiver assembly. |
| No. 1 Stereo Jack Adapter Assembly | ·
When a USB memory device, portable audio player (USB type) or Apple device is connected, communicates with the radio and display receiver assembly via USB. |
| Combination Meter Assembly | ·
Displays various information and operation signals on the multi-information display sent from the radio and display receiver assembly via local bus communication. ·
Sends the vehicle speed signal to the radio and display receiver assembly. |
| Skid Control ECU (Brake Actuator Assembly)*3 | Sends the parking brake position signal to the radio and display receiver assembly. |
| No. 2 Skid Control ECU (Brake Actuator Assembly)*4 | |
| Park/Neutral Position Switch Assembly*3 | Sends the R shift position signal to the radio and display receiver assembly. |
| Instrument Panel Junction Block Assembly*4
·
BKUP LP Relay |
Sends the R shift position signal to the radio and display receiver assembly. |
DIAGNOSIS
For details on the procedure required to enter the Service Menu screen, refer to the Repair Manual.