SYSTEM CONTROL
The panoramic moon roof system has the following functions:
| Function | Outline |
|---|---|
| Manual Open-and-close | Opens (or closes) the panoramic moon roof when the roof open/close/vent switch is slid backward (or forward) for less than 0.3 seconds. The panoramic moon roof stops as soon as the switch is released. |
| One-touch Auto Open | Opens the panoramic moon roof to the fully opened position when the open/close/vent switch is slid backward for 0.3 seconds or more. |
| One-touch Auto Close | Closes the panoramic moon roof to the fully tilted-up position when the roof open/close/vent switch is slid forward for 0.3 seconds or more. |
| Manual Tilt Up | Tilts the panoramic moon roof up when the open/close/vent switch is pressed for less than 0.3 seconds. |
| Manual Tilt Down | Tilts the panoramic moon roof down when the vent switch is pressed and held or the roof open/close switch or shade open/close switch is slid forward and held. The panoramic moon roof stops as soon as the switch is released. |
| One-touch Auto Tilt Up | Tilts the panoramic moon roof up when the open/close/vent switch is pressed for 0.3 seconds or more. |
| Jam Protection | Automatically stops the panoramic moon roof and moves it to the halfway open position (or fully tilted-up position) if foreign matter gets jammed in the panoramic moon roof during a close or tilt down operation. |
| Key Off Operation | Makes it possible to operate the sliding roof for approximately 45 seconds after the ignition switch is turned from ON to off, if the driver or front passenger door is not opened. |
| Panoramic Moon Roof Open Warning | When the ignition switch is turned from ON to off and the driver door is opened with the sliding roof open, a warning message appears on the multi-information display and the buzzer sound once. |
The panoramic moon roof ECU memorizes the initial position of the panoramic moon roof. This memory is not cleared if the cable is disconnected from the negative (-) battery terminal. However, initialization is necessary if the sliding roof drive gear assembly is replaced. For details, refer to the Repair Manual.
| Function | Outline |
|---|---|
| Manual Open-and-close | Opens (or closes) the roof sunshade when the shade open/close switch is slid backward (or forward) for less than 0.3 seconds. The roof sunshade stops as soon as the switch is released. |
| One-touch Auto Open | Opens the roof sunshade to the fully opened position when the shade open/close switch is slid backward for 0.3 seconds or more. |
| One-touch Auto Close | ·
When the panoramic moon roof is not fully closed, sliding the shade open/close switch forward for 0.3 seconds or more closes the roof sunshade to the half-opened position. ·
When the panoramic moon roof is fully closed, sliding the shade open/close switch forward for 0.3 seconds or more fully closes the roof sunshade. |
| Jam Protection | Automatically stops the roof sunshade and moves it to the halfway open or fully open position if foreign matter gets jammed in the roof sunshade during close operation. |
Jam Protection Function
To control the jam protection function, the panoramic moon roof ECU (sliding roof drive gear assembly) monitors the amount of movement and judges jamming of the panoramic moon roof based on the pulse signals from Hall IC1 and the movement direction of the panoramic moon roof from the phase difference between the pulses signals of Hall IC1 and Hall IC2.
To control the jam protection function, the roof sunshade ECU (sliding roof drive gear assembly) monitors the amount of movement and judges jamming of the roof sunshade based on the pulse signals from Hall IC1 and the movement direction of the roof sunshade from the phase difference between the pulses signals of Hall IC1 and Hall IC2.
OPERATION
The panoramic moon roof and roof sunshade operate as follows:
| Operating Condition | When any roof or shade switch is operated with either of the following conditions met:
·
ignition switch is ON ·
Open/close/vent switch is operated after ignition switch is turned from ON to ACC or off. |
Automatic operation begins after sliding the switch backward or forward or pressing the switch for 0.3 seconds or more.
Manual operation operates when sliding the switch backward or forward or pressing the switch for less than 0.3 seconds.
Automatic operation can be stopped by operating the roof open/close/vent switch or shade open/close switch.
| No. | Roof Glass Position | Shade Position | Operation |
|---|---|---|---|
| [1] | ·
Fully closed position ·
Between fully closed position and fully tilted-up position ·
Fully opened position |
·
Fully closed position ·
Between fully closed position and half-opened position |
1.
The shade will open to the fully opened position. 2.
Simultaneously, the roof glass will fully opened. |
| [2] | ·
Half-opened position ·
Between half-opened position and fully opened position |
||
| [3] | Fully opened position | The roof glass will fully open. | |
| [4] | ·
Fully tilted-up position ·
Between fully tilted-up position and comfort stop position ·
Fully opened position |
·
Half-opened position ·
Between half-opened position and fully opened position |
1.
The shade will open to the fully opened position. 2.
Simultaneously, the roof glass will fully opened. |
| [5] | Fully opened position | The roof glass will open to the fully opened position. |
| *a | Shade Fully Closed | *b | Shade Half-opened |
| *c | Shade Fully Opened | *d | Roof Glass Fully Closed |
| *e | Roof Glass Fully Tilted-up | *f | Roof Glass Fully Opened |
|
Automatic/Manual Operation | - | - |
| No. | Roof Glass Position | Shade Position | Operation |
|---|---|---|---|
| [1] | ·
Fully opened position ·
Between fully tilted-up position and fully opened position |
·
Half-opened position ·
Between half-opened position and fully opened position |
The roof glass will slide closed to the fully tilted-up position. |
| [2] | ·
Between fully closed position and fully tilted-up position ·
Fully tilted-up position |
Entire range | The roof glass will tilt down to the fully closed position by manual operation. |
| *a | Shade Fully Closed | *b | Shade Half-opened |
| *c | Shade Fully Opened | *d | Roof Glass Fully Closed |
| *e | Roof Glass Fully Tilted-up | *f | Roof Glass Fully Opened |
|
Automatic/Manual Operation |
|
Manual Operation |
| No. | Roof Glass Position | Shade Position | Operation |
|---|---|---|---|
| [1] | Entire range | Entire range | The shade will open to the fully opened position. |
| *a | Shade Fully Closed | *b | Shade Half-opened |
| *c | Shade Fully Opened | *d | Roof Glass Fully Closed |
| *e | Roof Glass Fully Tilted-up | *f | Roof Glass Fully Opened |
|
Automatic/Manual Operation | - | - |
| No. | Roof Glass Position | Shade Position | Operation |
|---|---|---|---|
| [1] | ·
Fully opened position ·
Between fully opened position and fully tilted-up position |
·
Fully opened position ·
Between half-opened position and fully opened position |
1.
The shade will close to the half-opened position. 2.
Simultaneously, the roof glass will close to the fully tilted-up position. |
| [2] | Fully tilted-up position | The shade will close to the half-opened position. | |
| [3] | Between fully tilted-up position and fully opened position | Half-opened position | The roof glass will close to the fully tilted-up position. |
| [4] | ·
Fully tilted-up position ·
Between fully closed position and fully tilted-up position |
·
Half-opened position ·
Between fully closed position and half-opened position |
1.
The roof glass will close to the fully closed position by manual operation (the switch is slid forward and held). 2.
While holding the switch, the shade will close to the fully closed position. |
| [5] | Fully closed position | ·
Between fully closed position and fully opened position ·
Fully opened position |
The shade will close to the fully closed position. |
| *a | Shade Fully Closed | *b | Shade Half-opened |
| *c | Shade Fully Opened | *d | Roof Glass Fully Closed |
| *e | Roof Glass Fully Tilted-up | *f | Roof Glass Fully Opened |
|
Automatic/Manual Operation |
|
Manual Operation |
| No. | Roof Glass Position | Shade Position | Operation |
|---|---|---|---|
| [1] | ·
Fully closed position ·
Between fully closed position and fully tilted-up position |
·
Fully closed position ·
Between fully closed position and half-opened position |
1.
The shade will open to the half-opened position. 2.
Simultaneously, the roof glass will open to the fully tilted-up position. |
| [2] | ·
Half-opened position ·
Between half-opened position and fully opened position ·
Fully opened position |
The roof glass will open to the fully tilted-up position. | |
| [3] | ·
Between fully tilted-up position and fully open position ·
Fully opened position |
The roof glass will close to the fully tilted-up position. | |
| [4] | Fully tilted-up position | The roof glass will close to the fully closed position by manual operation. |
| *a | Shade Fully Closed | *b | Shade Half-opened |
| *c | Shade Fully Opened | *d | Roof Glass Fully Closed |
| *e | Roof Glass Fully Tilted-up | *f | Roof Glass Fully Opened |
|
Automatic/Manual Operation |
|
Manual Operation |