FUNCTION OF MAIN COMPONENTS
| Component | Function | |
|---|---|---|
| Vehicle Approaching Speaker Controller | Controls starting and stopping of operation, sound pitch and volume level based on signals received from the hybrid vehicle control ECU and skid control ECU. | |
| Vehicle Approaching Speaker Assembly | Emits warning sounds based on the operation signal received from the vehicle approaching speaker controller. | |
| Hybrid Vehicle Control ECU | ·
Outputs a shift position signal to the vehicle approaching speaker controller. ·
Outputs an engine running signal to the vehicle approaching speaker controller. ·
Outputs a stop light switch signal to the vehicle approaching speaker controller. ·
Outputs a front motor speed signal to the vehicle approaching speaker controller. |
|
| Combination Meter Assembly | Multi-information Display | Displays a warning message when there is a malfunction in the vehicle proximity notification system. |
| Brake Actuator Assembly | No. 2 Skid Control ECU | Outputs a vehicle speed signal to the vehicle approaching speaker controller. |
| Network Gateway ECU | Transmits the signal between the CAN communication bus. | |
OPERATING CONDITION
| Condition | Outline |
|---|---|
| System Active | The vehicle proximity notification system operates (emits a warning sound) when all of the following conditions are met:
·
The shift position is any position other than P. ·
The engine is stopped. ·
The vehicle speed is 25 km/h (15 mph) or less. ·
Any of the following conditions are met: -
The vehicle speed exceeds 0 km/h (0 mph) -
Stop light switch is turned from on to off. -
The front motor speed exceeds 32 rpm |
| System Stop | The vehicle proximity notification system stops operating when any of the following conditions are met:
·
The shift position is P. ·
The engine starts. ·
The vehicle speed is more than 25 km/h (15 mph). ·
Approximately more than 0.24 seconds passed with all the following conditions are met: -
The vehicle speed of 0 km/h (0 mph) -
The front motor speed of 32 rpm or less -
Stop light switch on signal is received ·
Approximately more than 3 seconds passed with all the following conditions are met: -
The vehicle speed of 0 km/h (0 mph) -
The front motor speed of 32 rpm or less -
Stop light switch off signal is received |
All conditions are the same when the vehicle reverses.
SYSTEM CONTROL
| Control | Outline |
|---|---|
| Vehicle Speed Linked Control | ·
Emits the warning sound by controlling the pitch of the sound in accordance with the vehicle speed. ·
The warning sound becomes higher as the vehicle accelerates and it becomes lower as the vehicle decelerates. |
| Fade-in/Fade Out Control | When the system starts operating, the warning sound volume gradually increases, and when system operation is stopped, the sound volume gradually decreases. |
FUNCTION
Warning Indication
The combination meter assembly uses the multi-information display to notify the driver of vehicle proximity notification system malfunctions.
When the system is not available, the following warning occurs to warn the driver.
| Multi-information Display | Detail | DTC |
|---|---|---|
| Proximity Notification System Malfunction Visit Your Dealer | This message appears when the vehicle approaching speaker controller detects a system malfunction | Repair is required DTCs are stored |
DIAGNOSIS
The vehicle approaching speaker controller will also store Diagnostic Trouble Codes (DTCs). The DTCs can be read by using the Global Techstream (GTS). For details, refer to the Repair Manual.