Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM (for HV Model) › 2020.11–2021.10
NM37A0E _57 Power Source / Network _086694 NETWORKING _0419116 CAN COMMUNICATION SYSTEM(for HV Model) CO CONTROL F

NETWORKING  CAN COMMUNICATION SYSTEM(for HV Model)  CONTROL  CAN COMMUNICATION CONTROL  


FUNCTION


CAN Connection Components

*1: Models with Toyota safety sense

*2: Models with Toyota parking assist sensor system

*3: Models with panoramic view monitor system

*4: Models with blind spot monitor system

*5: Models with seat position memory system

*6: Models with headup display system

*7: 4WD/AWD models

*8: Models with power back door system

*9: Models with 12.3-inch display

*10: Models with Toyota multi operation touch system

*11: Models with telematics transceiver

*12: Models with panoramic view monitor system orparking assist monitor system

*13:Models with vehicle proximity notification system

Central Gateway ECU (Network Gateway ECU) Forward Recognition Camera*1
Millimeter Wave Radar Sensor Assembly*1 Clearance Warning ECU Assembly*2
Parking Assist ECU*3 Blind Spot Monitor Sensor LH*4
Rear Television Camera Assembly*12 Hybrid Vehicle Control ECU
Vehicle Approaching Speaker Controller*13 No. 1 Skid Control ECU (Brake Booster with Master Cylinder Assembly)
Combination Meter Assembly ECM
Tire Pressure Warning ECU and Receiver No. 2 Skid Control ECU (Brake Actuator Assembly)
Airbag Sensor Assembly Outer Mirror Control ECU Assembly RH*5
Steering Sensor Outer Mirror Control ECU Assembly LH*5
Power Steering ECU (Rack and Pinion Power Steering Gear Assembly) Certification ECU (Smart Key ECU Assembly)
Position Control ECU Assembly LH*5 Position Control ECU Assembly RH*5
Meter Mirror Sub-assembly*6 Inverter with Converter Assembly*7
Radio and Display Receiver Assembly Main Body ECU (Multiplex Network Body ECU)
Yawrate Sensor Multiplex Network Door ECU*8
Air Conditioning Amplifier Assembly Radio Receiver Assembly*9
Integration Control Sub-assembly*10 Swing Grille Actuator Assembly
DCM (Telematics Transceiver)*11 -


DIAGNOSIS


a.

If a malfunction occurs on a CAN communication bus, ECUs that are connected to the CAN communication bus store Diagnostic Trouble Codes (DTCs) in memory.


b.

The 5-digit DTCs can be read by connecting the GTS to the DLC3.


c.

For details, refer to the Repair Manual.