FUNCTION OF MAIN COMPONENTS
| Component | Function |
|---|---|
| Integration Control Sub-assembly | ·
Combines the screen received from the radio receiver assembly with other operation screens such as the control menus for the air conditioner, seat heater, etc., then outputs the combined image signal to the multi-display assembly. ·
Sends operation signals received from the multi-display assembly to the radio receiver assembly and the ECU of each respective system. |
| Multi-display Assembly | ·
Decode and displays the image signal received from the integration control sub-assembly. ·
Sends touch operation signals to the integration control sub-assembly and radio receiver assembly. |
| Radio Receiver Assembly | Sends the multimedia screen signal to the integration control sub-assembly. |
FUNCTION
Toyota multi operation touch system display function
The following items can be operated or displayed using the Toyota multi operation touch system:
| System | Function*1 | Display/Operation Item*1 |
|---|---|---|
|
*1: Depending on the vehicle specifications, each item or switch may not be displayed. *2: Toyota multi operation touch system can display the item but cannot change it. |
||
| Air conditioner | Front side | Switches air outlet mode |
| Temperature setting (for Driver Side) | ||
| Temperature setting (for Passenger Side) | ||
| Airflow volume | ||
| Rear side | AUTO*2 | |
| OFF*2 | ||
| Switches air outlet mode | ||
| Temperature setting | ||
| Airflow volume | ||
| OPTION | SYNC ON/OFF | |
| Seat | Driver side | Seat heater temperature setting |
| Climate control seat airflow volume setting | ||
| Passenger side | Seat heater temperature setting | |
| Climate control seat airflow volume setting | ||
| Vehicle settings | Drive mode*2 | NORMAL |
| SPORT | ||
| ECO | ||
| Multi-terrain select*2 | ROCK & DIRT | |
| MUD & SAND | ||
| SETTING | Slide Operation | |
Customize parameters
By selecting "Setting", the following items can be customized:
| Item | Details |
|---|---|
| Slide Operation | The flick function can be set to on or off. |
DIAGNOSIS
In order to make system inspections easier to perform, a diagnosis function is used in consideration of serviceability. The DTCs of malfunctioning parts can be read by connecting the GTS. Refer to the Repair Manual for details.