Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER SYSTEM (for HV Model) › from 2021.10
NM37A0E _59 Vehicle Exterior _088418 EXTERIOR PANELS / TRIM _0457332 GRILLE SHUTTER SYSTEM(for HV Model) CO CONTROL F

EXTERIOR PANELS / TRIM  GRILLE SHUTTER SYSTEM(for HV Model)  CONTROL  GRILLE SHUTTER CONTROL  


FUNCTION OF MAIN COMPONENTS


Item Function
Radiator Shutter Sub-assembly The fins of the radiator shutter sub-assembly are closed by the swing grille actuator assembly to block the airflow to the engine compartment.
Swing Grille Actuator Assembly Actuates the radiator shutter sub-assembly based on the control signal from the ECM LIN communication.
Air Conditioning Amplifier Assembly Sends the A/C refrigerant pressure signal and outside temperature signal to the ECM via CAN communication.
Hybrid Vehicle Control ECU Sends a vehicle speed signal and inverter coolant temperature signal to the ECM via CAN communication.
ECM
·

Controls the swing grille actuator assembly based on the signal from the engine coolant temperature signals, air conditioning amplifier assembly, and hybrid vehicle control ECU via LIN communication.

·

Sends a diagnosis signal to the combination meter assembly when a malfunction is detected.


Combination Meter Assembly Displays a message on the multi-information display to alert the driver with a signal provided by the ECM.
Central Gateway ECU (Network Gateway ECU) Relays data between buses.


OPERATION


a.

ECM does the cold condition control while the engine coolant temperature and hybrid inverter coolant temperature is low.


b.

ECM does the high speed traveling control.

Item Description
Cold Condition Control
·

When the ignition switch is on at the engine coolant temperature is below 40 °C (104 °F) , the grille shutter is closed until the engine coolant temperature at the 75 °C (167 °F).

·

Using the air conditioner in low outside temperature, the grille shutter is opened when the pressure of the refrigerant becomes higher.


High Speed Traveling Control
·

Vehicle traveling speed is between approximately 37 to 93 mph (60 to 150 km/h), the grille shutter is closed.

·

When the vehicle is traveling and engine coolant temperature is approximately 97 °C (207 °F) or more, the grille shutter is opened.

·

When the vehicle is traveling and outside temperature is approximately 35 °C (95 °F) or more, the grille shutter is opened.

·

When the vehicle is traveling and air conditioning refrigerant pressure is high, the grille shutter opens and closes in accordance with the vehicle speed and the outside air temperature, etc.



HINT:

Sometimes, the grille shutter operates after the ignition switch turned on (IG) or turned off. This does not indicate a malfunction.




FUNCTION


a.

Warning Indication

i.

The combination meter assembly uses the multi-information display and buzzer to provide the driver with grille shutter system malfunction.


ii.

When the system is not available, the following warning occurs to warn the driver.

When a system malfunction is detected
Multi-information Display Detail Buzzer DTC
Grille Shutter Malfunction Visit Your Dealer This message appears when the ECM detects a system malfunction Sounds once Repair is required DTCs are stored
Grille Shutter not Initialized.
Cancel Maintenance Mode
This message appears when the ECM detects a maintenance mode - -

HINT:

The maintenance mode can be cancel using the GTS or driving the vehicle. For details, refer to the Repair Manual.





DIAGNOSIS


a.

If the ECM detects a malfunction in the grille shutter system, Diagnostic Trouble Codes (DTCs) are stored in the ECM.

i.

The 7-digit DTCs can be read by connecting the GTS to the DLC3. For details, refer to the Repair Manual.