Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
87961
1.REMOVE OUTER MIRROR
|
Protective Tape |
Apply protective tape to the areas shown in the illustration.
Push the upper part of the mirror surface and tilt it.
Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape and moulding remover, disengage the 8 claws as shown in the illustration.
for Type A:
w/ Blind Spot Monitor System:
Disengage the 2 claws.
| *A | w/ Blind Spot Monitor System: |
Disconnect each connector to remove the outer mirror.
for Type B:
w/o Blind Spot Monitor System:
Disconnect the 2 connectors to remove the outer mirror.
w/ Blind Spot Monitor System:
Disengage the 3 clamps.
Disconnect the 3 connectors to remove the outer mirror.