Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (INTAKE / EXHAUST) › INTAKE SYSTEM
RM37A0E _51 Engine / Hybrid System _086909 A25A-FXS, A25B-FXS INTAKE / EXHAUST _0416451 INTAKE SYSTEM G

A25A-FXS, A25B-FXS INTAKE / EXHAUST  INTAKE SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Air leak from intake system is repaired Perform Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.INSPECT INTAKE SYSTEM

CAUTION:
A345137

To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when working in the engine compartment with the engine running or the ignition switch ON.


a.

Check that there are no vacuum leaks at the points shown in the illustration.

HINT:

Perform "Inspection After Repair" after repairing vacuum leaks in the intake system.

Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


A457809


Hide 2.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after repairing vacuum leaks in the intake system.

Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION