The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly (TWC: Rear Catalyst) and tail exhaust pipe assembly removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
17430
1.REMOVE TAIL EXHAUST PIPE ASSEMBLY
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Remove the 2 bolts and disconnect the tail exhaust pipe assembly from the front exhaust pipe assembly (TWC: Rear Catalyst).
Remove the tail exhaust pipe assembly from the 4 exhaust pipe supports.
Remove the gasket from the front exhaust pipe assembly (TWC: Rear Catalyst).
89467C
2.REMOVE AIR FUEL RATIO SENSOR (for Sensor 2)
17410
3.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Remove the 2 nuts and disconnect the front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust manifold (TWC: Front Catalyst).
Remove the front exhaust pipe assembly (TWC: Rear Catalyst) from the 2 exhaust pipe supports.
Remove the gasket from the front exhaust pipe assembly (TWC: Rear Catalyst).