Home › Engine / Hybrid System › 2GR-FKS (INTAKE / EXHAUST) › INTAKE SYSTEM › 2020.02–2020.11
RM37A0E _51 Engine / Hybrid System _086854 2GR-FKS INTAKE / EXHAUST _0416456 INTAKE SYSTEM G

2GR-FKS INTAKE / EXHAUST  INTAKE SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Air leak from intake system is repaired Perform Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.INSPECT INTAKE SYSTEM

CAUTION:
A345137

To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or the ignition switch ON.


a.

Check that there are no vacuum leaks at the points shown in the illustration.

HINT:

Perform Inspection After Repair after repairing vacuum leaks in the intake system.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


A459701


Hide 2.INSPECT INTAKE AIR CONTROL VALVE (for ACIS)

a.
A454223C01
1.167,2.521 1.167,2.854 true 1.115,2.906 1.292,3.094 0.177,0.188 10 true *a
*a Actuator Rod


When Activate the VSV for Intake Control is set to on, check that the actuator rod operates.

Powertrain > Engine > Active Test
Tester Display
Activate the VSV for Intake Control
50004 372 47

If the actuator rod does not operate, inspect the intake air control valve (for ACIS) and No. 1 vacuum switching valve assembly (for ACIS).



b.

When Activate the VSV for Intake Control is set to off, check that the actuator rod returns to its original position.

If the actuator rod does not return to its original position, inspect the intake air control valve (for ACIS) and No. 1 vacuum switching valve assembly (for ACIS).



Hide 3.PERFORM INITIALIZATION

a.

Perform Inspection After Repair after repairing vacuum leaks in the intake system.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION