Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (EMISSION CONTROL) › EMISSION CONTROL SYSTEM
RM37A0E _51 Engine / Hybrid System _086908 A25A-FXS, A25B-FXS EMISSION CONTROL _0416571 EMISSION CONTROL SYSTEM G

A25A-FXS, A25B-FXS EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.VISUALLY CHECK HOSES, CONNECTIONS AND GASKETS

a.

Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil level dipstick, oil filler cap sub-assembly, ventilation hose or other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body with motor assembly and cylinder head sub-assembly will cause engine failure or engine malfunctions.



If any defects are found, replace parts as necessary.


Hide 2.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

CAUTION:
A345137

To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when working in the engine compartment with the engine running or the ignition switch ON.


a.

Put the engine in Inspection Mode (Maintenance Mode).

Powertrain > Hybrid Control > Utility
Tester Display
Inspection Mode
50005 397 3103

b.
A457796

Disconnect the No. 1 fuel vapor feed hose from the purge valve (purge VSV).


c.

Check that vacuum occurs at the purge valve (purge VSV) port.

Powertrain > Engine > Active Test
Tester Display
Activate the EVAP Purge VSV
50004 372 1

d.

If vacuum does not occur, check the following items.

·

Purge valve (purge VSV)

·

Clogging in the No. 2 fuel vapor feed hose that connects the intake manifold and purge valve (purge VSV)



e.

Exit Active Test mode and connect the No. 1 fuel vapor feed hose.

If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.


f.

Warm up the engine and drive the vehicle.


g.

Confirm that the purge valve (purge VSV) opens.

Powertrain > Engine > Data List
Tester Display
EVAP (Purge) VSV
50003 372 226

If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.