The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear combination light assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
81498
1.REMOVE REAR COMBINATION LIGHT COVER
|
Insert Moulding Remover Here |
|
Remove in this Direction |
Using a moulding remover, disengage the 2 claws and guide as shown in the illustration.
|
Remove in this Direction |
Disengage the 2 claws and 2 guides to remove the rear combination light cover as shown in the illustration.
2.REMOVE REAR COMBINATION LIGHT SUB-ASSEMBLY
|
Protective Tape |
Apply protective tape around the rear combination light sub-assembly as shown in the illustration.
Remove the 2 screws.
| *a | Pin |
| *b | Guide |
|
Remove in this Direction |
Pull the rear combination light sub-assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light sub-assembly.
To prevent the rear combination light sub-assembly from falling when disengaging the pin and 3 guides, make sure to hold the rear combination light sub-assembly.
Disengage the 2 guides.
Disconnect 3 connectors to remove the rear combination light sub-assembly.
3.REMOVE REAR BUMPER ASSEMBLY
52563D
4.REMOVE REAR BUMPER UPPER RETAINER
81565D
5.REMOVE REAR COMBINATION LIGHT CORD
Disconnect the connector to remove the rear combination light cord.