Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM37A0E _59 Vehicle Exterior _086888 LIGHTING (EXT) _0416598 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.

Resistance Check

i.
E402229C01
1.25,1.802 1.417,1.219 true 0.948,1.802 1.198,1.219 true 2.167,1.802 2,1.219 true 2.417,1.802 2.167,1.219 true 0.167,0.177 0.479,0.333 0.313,0.156 10 false *a 0.833,1.833 1.448,2.031 0.615,0.198 10 false ILL+ 1.208,1.833 1.667,2.031 0.458,0.198 10 false TB 2.167,1.833 2.323,2.031 0.156,0.198 10 false E 2.385,1.833 3,2.031 0.615,0.198 10 false ILL-
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (TB) - 3 (E) Hazard warning switch off 10 kΩ or higher
Hazard warning switch on Below 50 Ω


If the result is not as specified, replace the hazard warning signal switch assembly.



b.

Illumination Inspection

i.

Apply auxiliary battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

OK:
Measurement Condition Condition Specified Condition
Auxiliary battery positive (+) → Terminal 7 (ILL+)
Auxiliary battery negative (-) → Terminal 2 (ILL-)
Always Switch illumination illuminates


If the result is not as specified, replace the hazard warning signal switch assembly.