Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM MAIN SWITCH
RM37A0E _59 Vehicle Exterior _086888 LIGHTING (EXT) _0416599 AUTOMATIC HIGH BEAM MAIN SWITCH G

LIGHTING (EXT)  AUTOMATIC HIGH BEAM MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84153 1.INSPECT AUTO HIGH BEAM SWITCH

a.

Inspect the automatic high beam main switch.

i.
E402775C16
1.25,1.771 1.469,1.292 true 2.198,1.771 1.969,1.292 true 2.5,1.75 2.177,1.292 true 0.917,1.75 1.292,1.292 true 1.583,1.917 1.625,1.292 true 1.906,1.844 1.813,1.292 true 0.094,0.083 0.406,0.24 0.313,0.156 10 false *a 1.156,1.802 1.615,2 0.458,0.198 10 false +B 2.167,1.792 2.625,1.99 0.458,0.198 10 false E 0.813,1.771 1.427,1.969 0.615,0.198 10 false ILL+ 2.448,1.76 3.063,1.958 0.615,0.198 10 false ILL- 1.438,1.969 2.052,2.167 0.615,0.198 10 false AZBI 1.833,1.854 2.448,2.052 0.615,0.198 10 false IND+
*a Component without harness connected
(Auto High Beam Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

If the result is not as specified, replace the auto high beam switch.

5 (B) - 2 (E) Automatic high beam main switch off 10 kΩ or higher
Automatic high beam main switch on Below 1 Ω




b.

Illumination Inspection

i.

Apply auxiliary battery voltage to the auto high beam switch and check that the switch illuminates.

OK:
Switch Illumination
Auxiliary Battery Connection Specified Condition
Auxiliary battery positive (+) → 6 (ILL+)
Auxiliary battery negative (-) → 1 (ILL-)
Switch illumination illuminates


OK:
Switch Indicator
Auxiliary Battery Connection Specified Condition
Auxiliary battery positive (+) → 3 (IND+)
Auxiliary battery negative (-) → 4 (AZBI)
Switch indicator illuminates


If the result is not as specified, replace the auto high beam switch.