Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR
RM37A0E _59 Vehicle Exterior _086888 LIGHTING (EXT) _0416601 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89120A 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.

Disconnect the G5 automatic light control sensor connector.


b.
E393536C05
1.542,0.25 1.875,0.5 0.333,0.25 0.906,1.688 1.406,1.188 true 1.635,1.698 1.615,1.208 true 0.354,0.26 0.667,0.417 0.313,0.156 10 false *a 1.615,0.292 2.073,0.49 0.458,0.198 11 false G5 1.479,1.719 2.094,1.917 0.615,0.198 10 false CLTE 0.708,1.719 1.323,1.917 0.615,0.198 10 false CLTB
*a Front view of wire harness connector
(to Automatic Light Control Sensor)


Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G5-1 (CLTB) - G5-2 (CLTE) Ignition switch off Below 1 V
Ignition switch on (IG) 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
G5-2 (CLTE) - Body ground Always Below 1 Ω


If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Connect the G5 automatic light control sensor connector.


d.

Connect an oscilloscope to terminals G5-2 (CLTE) and G5-4 (CLTS) of the automatic light control sensor connector and check the waveform.

E393537C04
1.688,0.792 2.104,0.979 0.417,0.188 1.156,2.094 1.656,1.677 true 2.323,2.083 1.99,1.667 true 0.521,0.677 0.833,0.833 0.313,0.156 10 false *a 3.5,0.677 3.813,0.833 0.313,0.156 10 false *b 1.833,0.792 2.292,0.99 0.458,0.198 10 false G5 6.375,2.083 6.833,2.281 0.458,0.198 10 false GND 0.958,2.115 1.406,2.313 0.448,0.198 10 false CLTS 2.208,2.115 2.656,2.313 0.448,0.198 10 false CLTE
*a Component with harness connected
(Automatic Light Control Sensor)
*b Waveform


OK:
Tester Connection Condition Tool Setting Specified Condition
G5-2 (CLTE) - G5-4 (CLTS) Ignition switch on (IG) 2 V/DIV., 10 ms./DIV. Pulse generation
(See waveform)


HINT:

The communication waveform changes according to the surrounding brightness.


If the result is not as specified, the automatic light control sensor may be malfunctioning.