Home › Vehicle Exterior › LIGHTING (EXT) › REAR FOG LIGHT ASSEMBLY › 2020.02–2020.11
RM37A0E _59 Vehicle Exterior _086888 LIGHTING (EXT) _0416603 REAR FOG LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR FOG LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear fog light assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Rear bumper assembly*
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Rear bumper assembly*
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR BUMPER ASSEMBLY

Hide 81490C 2.REMOVE REAR FOG LIGHT ASSEMBLY

a.
E435295

Disengage the 3 clamps.


b.

Disconnect the connector.


c.
E435296

Remove the 3 screws and rear fog light assembly.