Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2020.02–2020.11
RM37A0E _58 Vehicle Interior _086889 METER / GAUGE / DISPLAY _0416706 METER / GAUGE SYSTEM G

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT SPEEDOMETER

NOTICE:
·

The combination meter assembly receives the vehicle speed signal from the skid control ECU (brake booster with master cylinder assembly) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU (brake booster with master cylinder assembly) because it is the source of the vehicle speed signal.

·

Data List values of the skid control ECU (brake booster with master cylinder assembly) are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.

·

If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.



a.

Warm up the engine.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / Brake/EPB / Data List.


f.

Read the Data List according to the display on the GTS.

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Vehicle speed Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
Chassis > Brake/EPB > Data List
Tester Display
Vehicle Speed
50003 435 51
Reference:
GTS Indication (km/h) Acceptable Range (km/h)
20 21.0 to 25.0
40 41.7 to 46.2
60 62.7 to 67.2
80 83.4 to 88.4
100 104.3 to 109.3
120 125.1 to 130.6
140 145.8 to 151.8
160 166.2 to 173.2
180 186.9 to 194.5
200 207.7 to 215.7

OK:

Speedometer reading is within the acceptable range at each vehicle speed.



Hide 2.INSPECT TACHOMETER (for Gasoline Model)

a.

Warm up the engine.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine / Data List.


f.

Read the Data List according to the display on the GTS.

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Engine Speed Engine speed Min.: 0 rpm, Max.: 16383 rpm 650 to 750 rpm: Idling (shift lever in N, engine warmed up and A/C off) When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
Powertrain > Engine > Data List
Tester Display
Engine Speed
50003 372 211
Reference:
GTS Indication (rpm) Acceptable Range (rpm)
Data in ( ) is for Reference
700 630 to 770
1000 900 to 1100
2000 1850 to 2150
3000 2800 to 3200
4000 3800 to 4200
5000 4800 to 5200
6000 5750 to 6250
7000 6700 to 7300

OK:

Tachometer reading is within the acceptable range at each engine speed.



Hide 3.INSPECT WARNING OR INDICATOR LIGHT ILLUMINATION (INITIAL CHECK)

a.

for HV Model

i.

Turn the ignition switch off.


ii.

Turn the ignition switch to ON or ON (READY), and check the operation of the warning and indicator lights in the following table.

HINT:

The illumination of each warning light and indicator light varies.


OK:

All of the lights illuminate and then turn off.

Warning or Indicator Light
SRS warning light
EPS warning light
MIL (Check engine warning light)
Charge warning light
Brake warning light/red (malfunction)
Brake warning light/yellow (minor malfunction)
Brake hold standby indicator light
ABS warning light
VSC OFF indicator light
Slip indicator light
Speed warning light*5
Tire pressure warning light
PCS warning light*1
Clearance sonar OFF indicator light*2
PKSB OFF indicator light*2, *3
BSM OFF indicator light*4


*1: w/ Forward Recognition Camera

*2: w/ TOYOTA Parking Assist-sensor System

*3: w/ Parking Support Brake System

*4: w/ Blind Spot Monitor System

*5: w/ Speed warning




b.

for Gasoline Model

i.

Turn the ignition switch off.


ii.

Turn the ignition switch to ON, and check the operation of the warning and indicator lights in the following table.

HINT:

The illumination of each warning light and indicator light varies.


OK:

All of the lights illuminate and then turn off.

Warning or Indicator Light
SRS warning light
EPS warning light
MIL (Check engine warning light)
Charge warning light
Brake warning light/red (malfunction)
Brake warning light/yellow (minor malfunction)
Brake hold standby indicator light
ABS warning light
VSC OFF indicator light
Slip indicator light
Tire pressure warning light
Eco driving indicator light
PCS warning light*1
Clearance sonar OFF indicator light*2
PKSB OFF indicator light*2, *3
BSM OFF indicator light*4
Downhill assist control indicator light


*1: w/ Forward Recognition Camera

*2: w/ TOYOTA Parking Assist-sensor System

*3: w/ Parking Support Brake System

*4: w/ Blind Spot Monitor System