Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM37A0E _58 Vehicle Interior _086889 METER / GAUGE / DISPLAY _0416706 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Engine Oil Pressure Switch Circuit  


DESCRIPTION

The combination meter assembly and engine oil pressure switch assembly are connected via direct line. The combination meter assembly determines the engine oil pressure based on the engine oil pressure switch signal.

HINT:
·

The combination meter assembly receives various signals in order to output warnings from the ECM via CAN communication.

·

The combination meter assembly operates the following to output engine oil pressure warnings:

(a)

Engine oil pressure warning buzzer

(b)

Engine oil pressure warning message on multi-information display




WIRING DIAGRAM

E414068E10
1.5,1.156 2.104,1.417 0.604,0.26 10 false ECM 0.635,2.875 3.219,3.24 2.583,0.365 10 false Engine Oil Pressure Switch Assembly 0.635,2.719 1.094,2.917 0.458,0.198 10 false C36 4.833,2.875 5.146,3.073 0.313,0.198 10 false H21 4.823,3.031 7.115,3.229 2.292,0.198 10 false Combination Meter Assembly 4.948,2.094 5.563,2.292 0.615,0.198 10 false S 4.729,2.094 5.042,2.292 0.313,0.198 10 false 9 5.635,1.74 6.25,1.938 0.615,0.198 10 false 12 V 2.375,2.083 2.688,2.281 0.313,0.198 10 false 1 0.531,3.427 2.771,3.667 2.24,0.24 10 false : CAN Communication Line 2.146,2.083 2.76,2.281 0.615,0.198 10 false S

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

The following troubleshooting procedure is based on the assumption that the SFI system is normal. Confirm that the SFI system is not malfunctioning before performing the following procedure.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

OK

2.CHECK HARNESS AND CONNECTOR (ENGINE OIL PRESSURE SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)

NG

REPLACE ENGINE OIL PRESSURE SWITCH ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (ENGINE OIL PRESSURE SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the H21 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C36-1 (S) - H21-9 (S) Always Below 1 Ω
C36-1 (S) or H21-9 (S) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR