58944A
1.REMOVE REAR CONSOLE COVER
|
Remove in this Direction |
Disengage the 6 clips as shown in the illustration to remove the rear console cover.
55900D
2.REMOVE NO. 2 AIR CONDITIONING CONTROL ASSEMBLY
58923A
3.REMOVE CONSOLE REAR END PANEL
Disengage the clamp.
|
Protective Tape |
Apply protective tape to the area shown in the illustration.
|
Remove in this Direction |
Using a moulding remover, disengage the clip as shown in the illustration.
|
Remove in this Direction |
Using a moulding remover, disengage the clip as shown in the illustration.
|
Remove in this Direction |
Disengage the 6 clips as shown in the illustration to remove the console rear end panel.
85530D
4.REMOVE NO. 2 POWER OUTLET SOCKET ASSEMBLY
85535E
5.REMOVE NO. 2 POWER OUTLET SOCKET COVER
899A0A
6.REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
58825A
7.REMOVE CONSOLE BOX POCKET
Remove the console box pocket.
58906
8.REMOVE UPPER CONSOLE DOOR SUB-ASSEMBLY
Remove the 2 screws.
| *a | Stopper |
|
Pull |
|
Remove in this Direction |
While slightly pulling areas (A) and (B) in the direction shown in the illustration to enable the upper console door sub-assembly to pass over the stoppers, pull the upper console door sub-assembly in the direction shown in the illustration to remove it.
To prevent damage to the console box assembly, do not pull it excessively.
2 persons are required for this procedure.
82176
9.REMOVE REAR CONSOLE BOX WIRE
Disengage the 4 clips.
|
Remove in this Direction |
Disengage the 3 guides as shown in the illustration to remove the No. 1 box panel.
Disengage the 4 clips.
|
Remove in this Direction |
Disengage the 3 guides as shown in the illustration to remove the No. 3 box panel.
Disengage the 2 clamps.
|
Remove in this Direction |
Disengage the 6 claws as shown in the illustration to remove the No. 2 console mounting retainer.
Remove the 6 screws.
| *a | Clamp |
| *b | Guide |
Disengage the clamp and guide to remove the No. 1 trash box retainer support.
Disengage the 3 clamps to remove the rear console box wire.