Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 2GR-FKS)
RM37A0E _58 Vehicle Interior _086896 HEATING / AIR CONDITIONING _0417370 COMPRESSOR(for 2GR-FKS) G

HEATING / AIR CONDITIONING  COMPRESSOR(for 2GR-FKS)  INSPECTION  


PROCEDURE

Hide 1.INSPECT COOLER COMPRESSOR ASSEMBLY (COMPRESSOR SOLENOID)

E116970C05
1.115,2.427 1.531,2.01 false 2.344,2.448 1.99,2.01 false 0.24,0.219 0.552,0.375 0.313,0.156 10 *a 0.875,2.458 1.396,2.656 0.521,0.198 10 SOL+ 2.24,2.479 2.583,2.646 0.344,0.167 10 SOL-
*a Component without harness connected
(Cooler Compressor Assembly (Compressor Solenoid))


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (SOL-) - 2 (SOL+) 25°C (77°F) 10.1 to 11.1 Ω


If the resistance is not as specified, replace the cooler compressor assembly.


Hide 2.INSPECT COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR)

E270992C04
1.875,0.958 2.26,0.448 true 1.552,0.958 1.146,0.448 true 0.083,0.094 0.396,0.25 0.313,0.156 10 *a 2.313,0.302 2.813,0.469 0.5,0.167 10 SSR+ 0.802,0.323 1.302,0.49 0.5,0.167 10 SSR-
*a Component without harness connected
(Cooler Compressor Assembly (A/C Lock Sensor))


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (SSR+) - 2 (SSR-) 20°C (68°F) 160 to 320 Ω


If the resistance is not as specified, replace the cooler compressor assembly.


Hide 3.INSPECT COOLER COMPRESSOR ASSEMBLY (MAGNETIC CLUTCH ASSEMBLY)

E270992C05
1.271,1.74 1.708,1.396 true 0.063,0.083 0.375,0.24 0.313,0.156 10 *a 1.021,1.823 1.479,2.021 0.458,0.198 10 MG+
*a Component without harness connected
(Cooler Compressor Assembly (Magnetic Clutch Assembly))


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (MG+) - Body ground 20°C (68°F) 3.8 to 4.2 Ω


If the resistance is not as specified, replace the magnetic clutch assembly.


b.

Connect a positive (+) lead from the battery to terminal 3 (MG+) and check that the following occurs: 1) the magnetic clutch assembly operating sound can be heard, and 2) the magnetic clutch hub and rotor lock.

If the result is not as specified, replace the magnetic clutch assembly.