Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM37A0E _53 Suspension _086866 REAR SUSPENSION _0417443 REAR STABILIZER BAR G

REAR SUSPENSION  REAR STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR STABILIZER LINK ASSEMBLY

a.
C066721

Inspect the turning torque of the ball joint.

i.

Secure the rear stabilizer link assembly in a vise using aluminum plates.

NOTICE:

Do not overtighten the vise.



ii.

Install the nut to the rear stabilizer link assembly stud.


iii.

Move the stud back and forth several times. Using a torque wrench, turn the stud continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

Standard Turning Torque:

0.05 to 1.96 N*m (0.6 to 19 kgf*cm, 0.5 to 17 in.*lbf)


HINT:

If the turning torque is not within the specified range, replace the rear stabilizer link assembly with a new one.




b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.

HINT:

If the dust cover is cracked or there is grease on it, replace the rear stabilizer link assembly with a new one.