Home › Engine / Hybrid System › 2GR-FKS (FUEL) › FUEL PUMP
RM37A0E _51 Engine / Hybrid System _086852 2GR-FKS FUEL _0417512 FUEL PUMP A

2GR-FKS FUEL  FUEL PUMP  REASSEMBLY  


PROCEDURE

Hide 23221 1.INSTALL FUEL PUMP

HINT:

Perform "Inspection After Repair" after replacing the fuel pump.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A445839C01
1.021,0.469 1.26,0.469 1.26,0.469 1.51,0.667 true 1.031,0.854 1.531,0.854 true 0.854,0.396 1.167,0.552 0.313,0.156 10 false *1 0.854,0.781 1.167,0.938 0.313,0.156 10 false *2
*1 O-ring
*2 Fuel Pump Spacer


Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump.


b.

Install the fuel pump to the fuel suction plate sub-assembly.

NOTICE:

Make sure that the O-ring is not cut or pinched during installation.



c.

Engage the 3 claws to install the No. 2 fuel suction support to the fuel suction plate sub-assembly.


d.

Engage the 4 claws to install the fuel suction plate sub-assembly to the fuel sub-tank sub-assembly.


e.
A454429C01
1.979,0.854 2.104,0.854 2.104,0.854 2.302,1.146 true 2.844,1.594 2.677,1.594 2.677,1.594 2.469,1.26 true 1.781,0.781 1.948,0.938 0.167,0.156 10 true *a 2.917,1.51 3.083,1.667 0.167,0.156 10 true *b
*a Protrusion
*b Installation Hole
V100135

Slide


Align the protrusion of the fuel sub-tank sub-assembly with the installation hole of the fuel suction plate sub-assembly and then slide the fuel suction plate sub-assembly to install the fuel sub-tank sub-assembly.


f.

Engage the clamp to install the fuel pump harness to the fuel suction tube with pump and gauge assembly.

NOTICE:
·

Do not damage the wire harness.

·

When engaging each wire harness to the clamp, engage one wire at a time.




g.

Engage the claw and connect the ground terminal of the fuel pump harness.

NOTICE:
·

Securely engage the claw.

·

Make sure that there is no foreign matter between the fuel pump and the ground terminal of the fuel pump harness.

·

Make sure that the ground terminal of the fuel pump harness is securely connected to the fuel pump body.




h.
A474150

Check the connection state of the fuel pump harness.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Fuel pump body - Ground terminal of the fuel pump harness Always Below 50 Ω


If the result is not as specified, reconnect the fuel pump harness to the fuel pump so that the ground terminal of the fuel pump harness is securely connected to the fuel pump body.



i.

Connect the 3 fuel pump harness connectors.


Hide 83320 2.INSTALL FUEL SENDER GAUGE ASSEMBLY