Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
53341B
1.REMOVE HOOD INSULATOR (w/ Heater)
85035
2.REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)
| *a | Protective Tape |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration to separate the washer nozzle sub-assembly.
Be careful not to damage the windshield glass.
Disconnect the washer hose to remove the washer nozzle sub-assembly.
Washer nozzle sub-assemblies cannot be reused.
85380
3.REMOVE FRONT WASHER NOZZLE AND HOSE ASSEMBLY (w/ Heater)
Disconnect the connector.
Disconnect the washer hose.
Tie a string to the wire harness of the front washer nozzle and hose assembly.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Using a moulding remover, disengage the 2 claws as indicated by the arrows, in the order shown in the illustration to separate the front washer nozzle and hose assembly.
Be careful not to damage the windshield glass.
Pull the front washer nozzle and hose assembly from the hood sub-assembly to remove it.
Front washer nozzle and hose assemblies cannot be reused.
Leave the string inside the hood sub-assembly.
Remove the string from the wire harness of the front washer nozzle and hose assembly.