Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH
RM37A0E _59 Vehicle Exterior _086901 WIPER / WASHER _0417567 WASHER LEVEL WARNING SWITCH G

WIPER / WASHER  WASHER LEVEL WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 85397 1.INSPECT LEVEL WARNING SWITCH ASSEMBLY

HINT:

This check should be performed with the level warning switch assembly installed on the washer jar.


a.

Fill the washer jar with washer fluid.


b.
E158668C16
2.021,1.271 2.604,1.271 false 1.385,1.26 0.75,1.26 false 2.667,1.167 2.802,1.344 0.135,0.177 10 false S 0.573,1.167 0.708,1.344 0.135,0.177 10 false E 0.208,0.135 0.469,0.313 0.26,0.177 10 false *a
*a Component without harness connected
(Level Warning Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (S) - 2 (E) Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or higher* 10 kΩ or higher
Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or lower* Below 1 Ω


HINT:

*: The level warning switch assembly begins operating when the fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) depending on the vehicle condition.


If the result is not as specified, replace the level warning switch assembly.