Home › Vehicle Exterior › WIPER / WASHER › RELAY
RM37A0E _59 Vehicle Exterior _086901 WIPER / WASHER _0417570 RELAY G

WIPER / WASHER  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85948 1.INSPECT WIPER RELAY

a.
E367719C05
1.146,0.948 1.313,0.49 false 1.281,1.771 1.125,1.333 false 0.802,0.99 0.969,0.531 false 0.719,1.719 0.563,1.281 false 1.323,0.302 1.635,0.5 0.313,0.198 10 false 1 1.292,1.771 1.604,1.969 0.313,0.198 10 false 2 0.969,0.344 1.281,0.542 0.313,0.198 10 false 5 0.719,1.74 1.031,1.938 0.313,0.198 10 false 3 0.073,0.073 0.385,0.229 0.313,0.156 10 false *a
*a Component without harness connected
(WIPER Relay)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the WIPER relay.


Hide 87299C 2.INSPECT WSH NZL HTR RELAY

a.
E226254C04
2.094,0.76 2.323,0.76 false 2.885,0.76 3.115,0.76 false 2.781,1.115 3.115,1.115 false 2.792,1.563 3.115,1.563 false 1.969,0.698 2.219,0.938 0.25,0.24 10 false 1 3.167,1.063 3.333,1.24 0.167,0.177 10 false 5 3.167,1.49 3.323,1.708 0.156,0.219 10 false 3 3.146,0.688 3.354,0.917 0.208,0.229 10 false 2 0.156,0.115 0.469,0.313 0.313,0.198 10 false *a
*a Component without harness connected
(WSH NZL HTR Relay)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the WSH NZL HTR relay.