The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front door window frame moulding removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75720
1.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
67862
2.DISCONNECT FRONT DOOR WEATHERSTRIP
Disengage the 4 clips and disconnect the front door weatherstrip.
75756D
3.REMOVE FRONT DOOR WINDOW FRAME MOULDING
When removing the front door window frame moulding, heat the vehicle body and front door window frame moulding using a heat light.
| Item | Temperature |
|---|---|
| Front Door Window Frame Moulding and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body and front door window frame moulding excessively.
Using a heat light, heat the vehicle body and front door window frame moulding surface.
| *a | Double-sided Tape |
| *b | Caulking Sponge |
Using a moulding remover, disengage the clip, guide and separate the double-sided tape and caulking sponge to remove the front door window frame moulding.
75754A
4.REMOVE FRONT DOOR UPPER WINDOW FRAME MOULDING
Insert a 4.0 mm (0.157 in.) drill bit into a drill.
| *a | Tape |
Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.
| Area | Measurement |
|---|---|
| A | 5.0 mm (0.197 in.) |
Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.
Lightly press the drill bit against the rivets to drill off the rivet flanges, and remove the 6 rivets.
Be careful of the drilled rivets, as they may be hot.
Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
Prying the rivets with the drill may damage the rivet installation holes or drill bit.
Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled areas.
Disengage the guide to remove the front door upper window frame moulding from the door frame.