Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY
When removing the front door outside moulding sub-assembly, heat the vehicle body and front door outside moulding sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Front Door Outside Moulding Sub-assembly and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body and front door outside moulding sub-assembly excessively.
Disengage the 6 claws.
Remove the plug plate.
Remove the nut.
|
Protective Tape |
Apply protective tape around the front door outside moulding sub-assembly as shown in the illustration.
Using a heat light, heat the vehicle body and front door outside moulding sub-assembly.
Disengage the 12 clips and separate the double-sided tape to remove the front door outside moulding sub-assembly.
| *a | Double-sided Tape | - | - |
Remove the 12 clips from the front door outside moulding sub-assembly.