Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.INSTALL FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY
When installing the front door outside moulding sub-assembly, heat the vehicle body using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 20 to 30 °C (68 to 86 °F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body excessively.
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove any double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Install 12 new clips to the front door outside moulding sub-assembly.
Install the front door outside moulding sub-assembly.
Using a heat light, heat the vehicle body surface.
Remove the release paper from the front door outside moulding sub-assembly.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Engage the 12 clips and attach the double-sided tape.
Press the front door outside moulding sub-assembly firmly to install it.
Install the nut.
Install a new plug plate.
Engage the 6 claws to install the front door outside moulding sub-assembly.
Remove the protective tape.