Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR OUTSIDE MOULDING
RM37A0E _59 Vehicle Exterior _086903 EXTERIOR PANELS / TRIM _0417666 FRONT DOOR OUTSIDE MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR OUTSIDE MOULDING  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 67864F 1.REMOVE NO. 2 FRONT DOOR WEATHERSTRIP

a.
B565167

Disengage the 9 clips to remove the No. 2 front door weatherstrip.


Hide 75793 2.REMOVE FRONT DOOR UPPER OUTSIDE MOULDING PAD

a.

Remove the front door upper outside moulding pad.

B565168


Hide 75736A 3.REMOVE FRONT DOOR LOWER OUTSIDE MOULDING

a.

Insert a 4.0 mm (0.157 in.) drill bit into a drill.


b.
B360296C07
0.542,0.906 0.833,1.219 false 0.875,1.156 1.188,1.313 0.313,0.156 10 false *a 0.333,1.5 0.49,1.698 0.156,0.198 10 false A
*a Tape


Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.

Standard Measurement:
Area Measurement
A 5.0 mm (0.197 in.)


NOTICE:

Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.



c.

Lightly press the drill against the rivets to drill off the rivet flanges, and remove the 5 rivets and front door lower outside moulding.

B565170

CAUTION:

Be careful of the drilled rivets, as they may be hot.


NOTICE:
·

Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

·

Prying the rivets with the drill may damage the rivet installation holes or drill bit.




d.

Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled areas.