Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75736A
1.INSTALL FRONT DOOR LOWER OUTSIDE MOULDING
Using an air riveter or hand riveter with a nose piece, install the front door lower outside moulding with 5 new rivets.
If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.
| *a | Riveter |
| *b | Mandrel |
| *c | Incorrect |
Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
| *a | Riveter |
| *b | Incorrect |
Confirm that the rivets are seated properly against the moulding.
Do not tilt the riveter when installing the rivet to the moulding.
Do not leave any space between the rivet head and moulding.
| *a | Riveter |
| *b | Incorrect |
Do not leave any space between the moulding. Firmly hold the 2 items together while installing the rivet.
75793
2.INSTALL FRONT DOOR UPPER OUTSIDE MOULDING PAD
When installing the front door upper outside moulding pad, heat the front door outside moulding sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Front Door Outside Moulding Sub-assembly | 20 to 30 °C (68 to 86 °F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Clean the front door outside moulding sub-assembly.
Using a heat light, heat the front door outside moulding sub-assembly surface.
Remove any remaining double-sided tape from the front door outside moulding sub-assembly.
Wipe off any tape adhesive residue with cleaner.
Using a brush or felt, apply primer or equivalent to the front door upper outside moulding pad installation area.
Use a clean brush or felt.
Do not touch the front door outside moulding sub-assembly until the primer has dried.
Install a new front door upper outside moulding pad.
Using a heat light, heat the front door outside moulding sub-assembly surface.
Remove the release paper from the front door upper outside moulding pad.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Install the front door upper outside moulding pad as shown in the illustration.
| *a | Line | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 3 mm (0.118 in.) | B | 10 mm (0.394 in.) |
Press the front door upper outside moulding pad firmly to install it.
67864F
3.INSTALL NO. 2 FRONT DOOR WEATHERSTRIP
Engage the 9 clips to install the No. 2 front door weatherstrip.