Use the same procedures for the RH side and LH side.
The following procedure is for the LH side.
75078
1.REMOVE REAR DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY
When removing the rear door lower outside moulding sub-assembly, heat the vehicle body and rear door lower outside moulding sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Lower Outside Moulding Sub-assembly and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body and rear door lower outside moulding sub-assembly excessively.
Remove the 2 clips and screw.
|
Protective Tape |
Apply protective tape around the rear door lower outside moulding sub-assembly as shown in the illustration.
Using a heat light, heat the vehicle body and rear door lower outside moulding sub-assembly.
| *a | Double-sided Tape |
Disengage the 4 clips and separate the double-sided tape to remove the rear door lower outside moulding sub-assembly.
2.REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY
When removing the rear door outside moulding sub-assembly, heat the vehicle body and rear door outside moulding sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Outside Moulding Sub-assembly and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body and rear door outside moulding sub-assembly excessively.
Remove the clip.
Disengage the 5 claws.
Remove the plug plate.
Remove the nut.
|
Protective Tape |
Apply protective tape around the rear door outside moulding sub-assembly as shown in the illustration.
Using a heat light, heat the vehicle body and rear door outside moulding sub-assembly.
| *a | Double-sided Tape |
Disengage the 9 clips and separate the double-sided tape to remove the rear door outside moulding sub-assembly.
Remove the 9 clips from the rear door outside moulding sub-assembly.