The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during roof drip side finish moulding removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75597
1.REMOVE ROOF DRIP SIDE FINISH MOULDING JOINT COVER (w/o Roof Rack)
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Protective Tape |
Apply protective tape around the roof drip side finish moulding joint cover as shown in the illustration.
Disengage the 2 clips and 2 claws, and remove the 2 roof drip side finish moulding joint covers as indicated by the arrows, in the order shown in the illustration.
75552
2.REMOVE FRONT ROOF DRIP SIDE FINISH MOULDING (w/o Roof Rack)
|
Protective Tape |
Apply protective tape around the front roof drip side finish moulding.
Using a moulding remover, disengage the clip and remove the front roof drip side finish moulding.
Do not remove the roof drip side finish moulding clip.
If a roof drip side finish moulding clip is damaged or falls off, replace it with a new one.
75556C
3.REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING (w/o Roof Rack)
| *a | Matchmark |
|
Protective Tape |
Apply protective tape around the center roof drip side finish moulding.
Place a matchmark on the vehicle body at the location indicated in the illustration.
Using a moulding remover, disengage the clip and remove the center roof drip side finish moulding.
Do not remove the roof drip side finish moulding clip.
If the roof drip side finish moulding clip is damaged or falls out, replace it with a new one.
75554
4.REMOVE REAR ROOF DRIP SIDE FINISH MOULDING (w/o Roof Rack)
|
Protective Tape |
Apply protective tape around the rear roof drip side finish moulding.
Using a moulding remover, disengage the clip and remove the rear roof drip side finish moulding.
Do not remove the roof drip side finish moulding clip.
If the roof drip side finish moulding clip is damaged or falls out, replace it with a new one.
63470B
5.REMOVE ROOF RACK ASSEMBLY (w/ Roof Rack)
75554
6.REMOVE REAR ROOF DRIP SIDE FINISH MOULDING (w/ Roof Rack)
|
Protective Tape |
Apply protective tape around the rear roof drip side finish moulding.
Using a moulding remover, disengage and remove the rear roof drip side finish moulding.
Do not remove the roof drip side finish moulding clip.
If the roof drip side finish moulding clip is damaged or falls out, replace it with a new one.