Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
76626D
1.REMOVE REAR QUARTER PANEL MUDGUARD
75874
2.REMOVE QUARTER PANEL WHEEL OPENING MOULDING
When removing the quarter panel wheel opening moulding, heat the vehicle body and quarter panel wheel opening moulding using a heat light.
| Item | Temperature |
|---|---|
| Quarter Panel Wheel Opening Moulding and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body and quarter panel wheel opening moulding excessively.
|
Protective Tape |
Apply protective tape around the quarter panel wheel opening moulding as shown in the illustration.
Remove the 3 clips.
Remove the screw.
| *1 | Rear Bumper Side Seal |
|
Remove in this Direction |
While pulling the rear bumper assembly, insert a finger between the rear bumper side seal and rear bumper assembly and disengage the 3 claws as shown in the illustration.
Do not apply excessive force when pulling back the rear bumper side seal.
To avoid damaging the claws, do not forcibly pull the quarter panel wheel opening moulding.
Using a heat light, heat the vehicle body and quarter panel wheel opening moulding.
| *a | Double-sided Tape |
Disengage the 4 clips and separate the double-sided tape to remove the quarter panel wheel opening moulding.
Remove the spring nut.