Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75874
1.INSTALL QUARTER PANEL WHEEL OPENING MOULDING
When installing the quarter panel wheel opening moulding, heat the vehicle body using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body excessively.
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove any double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Install the spring nut.
Install a new quarter panel wheel opening moulding.
Using a heat light, heat the vehicle body.
Remove the release paper from the quarter panel wheel opening moulding.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Engage the 4 clips and attach the double-sided tape.
Press the quarter panel wheel opening moulding firmly to install it.
|
Install in this Direction |
Engage the 3 claws as shown in the illustration.
Install the quarter panel wheel opening moulding with the screw and 3 clips.
Remove the protective tape.
76626D
2.INSTALL REAR QUARTER PANEL MUDGUARD