Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › QUARTER PANEL WHEEL OPENING MOULDING
RM37A0E _59 Vehicle Exterior _086903 EXTERIOR PANELS / TRIM _0417672 QUARTER PANEL WHEEL OPENING MOULDING A

EXTERIOR PANELS / TRIM  QUARTER PANEL WHEEL OPENING MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 61668C 1.INSTALL NO. 2 QUARTER PANEL SEAL

HINT:

When installing the No. 2 quarter panel seal, heat the vehicle body using a heat light.


Heating Temperature:
Item Temperature
Vehicle Body 20 to 30°C (68 to 86°F)


CAUTION:
E306500C23
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the vehicle body excessively.


a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove any double-sided tape from the vehicle body.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new No. 2 quarter panel seal.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove the release paper from the No. 2 quarter panel seal.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



iii.

Attach the double-sided tape.

HINT:

Press the No. 2 quarter panel seal firmly to install it.



iv.

Install the No. 2 quarter panel seal with the 3 screws.



Hide 58588B 2.INSTALL REAR WHEEL HOUSE PAD