1. PRECAUTION
for Audio and Visual System:
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>PRECAUTION
for Navigation System:
After performing any of the following procedures, the navigation system may restart after turning the ignition switch to ACC for the first time (due to radio and display receiver assembly and navigation ECU certification).
Disconnecting and reconnecting the cable from the negative (-) terminal of the auxiliary battery, replacing the auxiliary battery, or recharging the auxiliary battery after being discharged.
Removing and installing or replacing the radio and display receiver assembly or navigation ECU.
After replacing the radio and display receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.
55405B
2.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
3.REMOVE RADIO AND DISPLAY ASSEMBLY WITH AIR CONDITIONING CONTROL
Remove the 4 bolts.
|
Remove in this Direction |
Pull the radio and display assembly with air conditioning control as shown in the illustration to disengage the 5 clips.
Disconnect each connector.
Disengage the 2 clamps to remove the radio and display assembly with air conditioning control.
4.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 screws.
Disengage the 3 claws to remove the radio and display receiver assembly with bracket.
86211J
5.REMOVE NO. 1 RADIO RECEIVER BRACKET
Remove the 2 screws and No. 1 radio receiver bracket.
86212C
6.REMOVE NO. 2 RADIO RECEIVER BRACKET
Remove the 2 screws and No. 2 radio receiver bracket.
86140A
7.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY