The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during navigation antenna assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55846A
2.REMOVE NO. 4 HEATER TO REGISTER DUCT
55843A
3.REMOVE NO. 1 HEATER TO REGISTER DUCT
55950G
4.REMOVE DEFROSTER NOZZLE ASSEMBLY
55972C
5.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
6.REMOVE NAVIGATION ANTENNA ASSEMBLY WITH BRACKET
Disconnect the connector.
Disengage the 2 claws.
Remove the 2 screws and navigation antenna assembly with bracket.
86860
7.REMOVE NAVIGATION ANTENNA ASSEMBLY
|
Remove in this Direction |
Disengage the 2 claws and 6 guides to remove the navigation antenna assembly as shown in the illustration.
86862
8.REMOVE NAVIGATION ANTENNA BRACKET