Home › Audio / Visual / Telematics › TELEMATICS › ANTENNA DIVIDER › 2020.02–2020.11
RM37A0E _56 Audio / Visual / Telematics _086879 TELEMATICS _0417875 ANTENNA DIVIDER A

TELEMATICS  ANTENNA DIVIDER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during antenna divider removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

CAUTION:
B401522

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 55846A 2.REMOVE NO. 4 HEATER TO REGISTER DUCT

Hide 55843A 3.REMOVE NO. 1 HEATER TO REGISTER DUCT

Hide 55950G 4.REMOVE DEFROSTER NOZZLE ASSEMBLY

Hide 55972C 5.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

Hide 86681B 6.REMOVE ANTENNA DIVIDER

a.
E435483

Disconnect the connector.


b.
E435484

Remove the 2 screws and antenna divider.