CUSTOMIZE WIPER AND WASHER SYSTEM
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
The following items can be customized.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Auto Wiper | Function to enable AUTO wiper operation | Avail | 0:Avail,1:Not Avl | Rain sensor |
| Rear Wiper Stop in Back Door/Trunk Lid Open | Function to enable the back door open linked rear wiper suspend function | Not Available | 0:Not Available,1:Available | Main body ECU (Multiplex network body ECU) |
| Rear Wiper Washer Function | Function to enable the rear washer linked rear wiper operation function | Available | 0:Not Available,1:Available | Main body ECU (Multiplex network body ECU) |
| Auto Rear Wiper in Reverse Setting | Function to enable the R shift position linked rear wiper operation function | Once | 00:Not Available,10:Once,11:Continuance | Main body ECU (Multiplex network body ECU) |
Changes to the customize settings will not be applied until the ignition switch is turned off then ON.